ウォトフォ

Remove the Pod: Take the pod out of the device by gently pulling it away.

Locate the Refill Port: Find the silicone plug or cap on the side or bottom of the pod.

Open the Refill Port: Lift or slide the silicone plug to expose the refill hole.

Refill the Pod: Use a dropper or bottle nozzle to fill the pod with your preferred e-liquid. Avoid overfilling.

Seal the Port: Close the refill port by securing the silicone plug back in place.

Reinsert the Pod: Place the filled pod back into the device.

Prepare the Cotton: Cut a strip of cotton that matches the width of your mesh coil.

Insert the Cotton: Thread the cotton strip through the mesh coil inside the RDA, ensuring it's snug but night.

Trim the Cotton: Use scissors to trim the excess cotton, leaving just enough to reach the bottom of the juice well.

Fluff the Cotton: Gently fluff the ends of the cotton to improve juice absorption.

Tuck the Cotton: Tuck the cotton ends into the juice well, ensuring it's evenly distributed.

Prime the Wick: Saturate the cotton with your e-liquid until it's thoroughy soaked.